VEGA VEGABAR 81 Profibus PA - Operating Instructions - Manual (Page 69)

69
11 Supplement
VEGABAR 81 • Profibus PA
45020-EN-131107
Status code Description according to
Profibus standard
Possible cause
0 x 04 bad - configuration error – Adjustment error
– Configuration error with PV-Scale (PV-Span too
small)
– Unit irregularity
– Error in the linearization table
0 x 0C bad - sensor failure – Hardware error
– Converter error
– Leakage pulse error
– Trigger error
0 x 10 bad - sensor failure – Measured value generation error
– Temperature measurement error
0 x 1f bad - out of service con-
stant
"Out of Service" mode switched on
0 x 44 uncertain - last unstable
value
Failsafe replacement value (Failsafe-Mode = "Last val-
ue" and already valid measured value since switching
on)
0 x 48 uncertain substitute set – Switch on simulation
– Failsafe replacement value (Failsafe-Mode = "Fsafe
value")
0 x 4c uncertain - initial value Failsafe replacement value (Failsafe-Mode = "Last valid
value" and no valid measured value since switching on)
0 x 51 uncertain - sensor; con-
version not accurate - low
limited
Sensor value < lower limit
0 x 52 uncertain - sensor; con-
version not accurate - high
limited
Sensor value > upper limit
0 x 80 good (non-cascade) - OK OK
0 x 84 good (non-cascade) - ac-
tive block alarm
Static revision (FB, TB) changed (10 sec. active, after
the parameter of the static category has been written)
0 x 89 good (non-cascade) - ac-
tive advisory alarm - low
limited
Lo-Alarm
0 x 8a good (non-cascade) - ac-
tive advisory alarm - high
limited
Hi-Alarm
0 x 8d good (non-cascade) - ac-
tive critical alarm - low
limited
Lo-Lo-Alarm
0 x 8e good (non-cascade) - ac-
tive critical alarm - high
limited
Hi-Hi-Alarm
11.3 Dimensions
The following dimensional drawings represent only an extract of the possible versions. Detailed
dimensional drawings can be downloaded at www.vega.com under "Downloads" and "Drawings".