C&H Technology PM50B4L1C060 - Manual (Page 5)

PM50B4L1C060
Photo Voltaic IPM
H-Bridge
50 Amperes/600 Volts
Powerex, Inc., 173 Pavilion Lane, Youngwood, Pennsylvania 15697 (724) 925-7272 www.pwrx.com
4 03/11 Rev. 0
Thermal Characteristics, T
j
= 25°C unless otherwise specified
Characteristic Symbol Condition Min. Typ. Max. Units
Junction to Case Thermal Resistance R
th(j-c)Q
Inverter IGBT (Per 1 Element)* 1 — — 0.74 °C/Watt
R
th(j-c)D
Inverter FWDi (Per 1 Element)* 1 — — 1.28 °C/Watt
Contact Thermal Resistance R
th(c-f)
Case to Fin (Per 1 Element)* 1 , — 0.060 — °C/Watt
Thermal Grease Applied
Recommended Conditions for Use
Characteristic Symbol Condition Value Units
Inverter Supply Voltage V
CC
Applied across P-N Terminals ≤450 Volts
Control Supply Voltage* 3 V
D
Applied between V
UP1
-V
UPC
, 15.0 ± 1.5 Volts
V
VP1
-V
VPC
, V
N1
-V
NC
Input ON Voltage V
CIN(on)
Applied between U
P
-V
UPC
, ≤0.8 Volts
Input OFF Voltage V
CIN(off)
V
P
-V
VPC
, U
N
- V
N
- W
N
-Br-V
NC
≥9.0 Volts
PWM Input Frequency f
PWM
Using Application Circuit Input Signal of IPM, ≤20 kHz
3-Phase Sinusoidal PWM VVVF Inverter
Arm Shoot-through Blocking Time t
DEAD
For IPMs Each Input Signals ≥2.0 µs
*1 When using this value, R th(s-a) should be measured just under the chips.
*3 With ripple satisfying the following conditions: dv/dt swing ≤5V/µs ; variation ≤2V peak-to-peak.