Atdec Telehook TH-PT24 Installation manual - Manual (Page 2)

Step 5. Assemble Projector Mount Interface onto Suspended Ceiling Plate
Step 6. Hook Suspended Ceiling Tile
1.5” NPT Bracket (included) Atdec Flush Mount
(TH-WH-PJ-FM supplied separately) Atdec Pole Mount
(TH-WH-PJ-CM supplied separately)
M6 Washer
(x4)
Hook Suspended Ceiling Tile to the Turnbuckles.
Twist Turnbuckles for height adjustment.
The Suspended Ceiling Tile should sit flush in ceiling grid.
Step 7. Fix Safety Wire
Thread one end of the Safety Wire through
a Lag Eye Bolt, Concrete Anchor, or Truss
and clamp using Safety Clamp.
Safety Clamp
Safety
Wire
Thread other end of Safety Wire
through the Suspended Ceiling Tile
and clamp using Safety Clamp.
Step 8. Install Projector Mount and Ceiling Cover (choose Ceiling Cover to suit projector mount)
Installation Complete - Ready to install Projector
Atdec Flush Mount
(TH-WH-PJ-FM supplied separately) Atdec Pole Mount
(TH-WH-PJ-CM supplied separately)
SCREW PUSH
PUSH
TIP: Use a spirit level to ensure
the Suspended Ceiling Tile is level.
TWIST
Wing Nuts
(x4)
Pole Upper
Mounting Plate
Pole Lower
Mounting Plate
Cover Plate
Wing Nuts
(x2)
M6 Washer
(x4)
M6x16mm
Screws (x2)
TH-WH-PJ-FM
Ceiling Plate
Cover Plate
M6 Washer
(x4)
Wing Nuts
(x4)
3mm
Allen Key
1.5” NPT Lower
Mounting Plate
1.5” NPT
Mounting Collar
(optional for 1.5”
projector heads only)
Cover Plate
M6 Set
Screws (x2)
1.5” NPT Pole Mount
(supplied separately)
TIGHTEN
2x NUTS
TIGHTEN
2x NUTS
OR OR
No portion of this document or any artwork contained herein should be reproduced in anyway without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published 31.03.11©
OR OR