Atdec Telehook TH-PS-D Installation manual - Manual

Step 2. Position Central Connector
Select the position of the Central
Connector before mounting the
Wall Plate to the wall.
TH-PS-D
Component Checklist
Short Throw Projector Wall Mount | Dual Stud
Support Arm
! IMPORTANT - Install Telehook Short Throw Projector Mount as per installation instruction.
! This product supports a maximum load of 25kg (55lbs.).
! The manufacturer accepts no responsibility for incorrect installation.
IMPORTANT INFORMATION:
Step 1. Check Components
Check you have received against the component checklist and hardware above.
Wall Plate
End Covers
Extrusions
HARDWARE
Coach Screw
(x6)
Nylon
Anchor (x6)
Washer (x6)
3mm Security
Allen Key
Security Screw (x2)
Tools Required:
• Power Drill
• 6mm(0.23”) Drill Bit
• 12mm(0.47”) Masonry Drill Bit
• 13mm (0.5”) Socket Wrench Shifter
• Phillips Head Screwdriver
Step 3. Mounting Wall Plate
Masonary Timber Stud
Coach Screw Coach Screw
Washer
Washer
Ø12mm x 65mm deep
Drilled Hole Ø6mm x 65mm deep
Drilled Hole Nylon Anchor
IMPORTANT! Any structural elements must be capable of supporting the combined weight of
all the equipment and devices being mounted. If in doubt, consult a structural engineer.
TIP: Use Mount as a drilling template.
Installation Instructions