Atdec Spacedec SD-POS-VBM-B2B Installation manual - Manual

A. Determine the degree of
rotation you require. (Refer to
Mounting Options above)
B. To Limit the Rotation,
use the 2.5mm Allen Key to
insert the supplied M5
Grub Screw into your
chosen Locking Hole until it
sits flush with the Base Plate.
NOTE: If you want the full
355° rotation, you do NOT
need to install a grub screw.
Step 1. Limit Rotation
Component Checklist (Check you have received all parts against the Component Checklist below)
M4x10mm Screws (x4)
M4x16mm Screws (x4)
POS Assembly (x1)
Hardware
2.5mm Allen Key (x1)
M4x12mm Screws (x4)
Installation Instructions
Installation Template
(x1)
M5 Grub Screw (x1)
4 x Ø3mm ( 1 /
8
”)
Pilot Holes
Centre for
45mm(1¾”) Cable
Access Hole
Mounting Options
A. Position the Installation
Template in the desired location
on your work surface. Ensure the
straight edge sits perpendicular
with the User’s line of sight. Mark
the center points of each of the
required holes onto the work
surface with a pencil.
B. Drill 4 x 3mm ( 1 /
8
”) Pilot
Holes to a depth of 15mm ( 9 /
16
”).
Use a 45mm (1¾”) hole saw to
drill the Cable Access Hole in the
work surface.
C. Reposition POS Multi with
the “Direction Arrow” pointing in
the direction required for your
chosen rotation. Secure the POS
to the work surface using the
supplied 14 Gauge Screws (x4).
INSTALLATION
TEMPLATE
Top Cap (x1)
Screw Cover
(x1)
14 Gauge Screws (x4)
0° Locking Hole (Fixed)
0-180° Locking Hole
0-270° Locking Hole
0-90° Locking Hole
Direction Arrow
Locking Holes
Rotation Options
0° Rotation (Fixed)
0-90° Rotation
0-180° Rotation
0-270° Rotation
0-355° Rotation
OR
4x
M5x75mm Screws
(To suit 70mm
4x M5
Cable Management
Hole
14 Gauge
Screws (x4)
Ø45mm
(1¾”) Cable
Access Hole
4 x Ø3mm ( 1 /
8
”)
Pilot Holes
USER
USER
5° Gap in
Rotation
USER
Step 2. Locate and Secure your POS Multi
5° Gap in
Rotation
270°
180°
0°
90° 270°
180°
0°
90°
355°
355°
M5 Grub Screw
Your POS Multi offers 355° of
Rotation. This can also be limited
to suit a specific application.
The Direction in which you
mount POS Multi will determine
where the 5° gap in Rotation is
located, and how you choose to
limit the rotation.
2.5mm Allen Key
Base Plate
Direction
Arrow
Direction
Arrow
2mm Allen Key (x1)
Display | POS Multi
SD-POS-VBM
Security Screw (x1) Tightening Tool (x1)
VESA plate (x1)