Atdec Spacedec SD-POS-VBM-B2B Installation manual - Manual (Page 2)

A. Loop the Security Cable
(Kensington or similar)
around the internal post
of the POS Assembly.
B. Feed the other end
of the cable through
the POS Assembly and
out the Cable
Management Hole.
C. After you have attached the monitor
(As directed in Step 8) install the lock to the
monitor as per the manufacturer guidelines.
Step 5. Install Top Cap
Step 4. (Optional) Install Monitor Security Cable (Security Cable NOT Included)
Prior to attaching your monitor,
install the monitor cables.
Run them through the Cable
Management Hole, down the
pole and out the Cable Access
Hole in the work surface.
Step 6. Install Monitor Cables
Top Cap
Cable
Management
Hole
OUT
IN
Step 3. Attach Screw Cover
Remove the paper backing from the Screw
Cover and adhere to the POS base as shown.
Screw
Cover
These Installation Instructions secure
the POS Multi using the provided
fasteners from above thework surface.
For advanced Security Installation from
below the work surface. Please refer to
the Advanced Security Installation
Addendum.
No portion of this document or any artwork contained herein should be reproduced in any way without the express written consent of Atdec Pty Ltd.
Due to continuing product development, the manufacturer reserves the right to alter specifications without notice. Published: 27.07.09 ©
Position your Display to the desired viewing
angle, using the 40° angular movement
allowed by the VESA Ball Mount.
If the display does not hold its position,
or is too resistant, adjust the Tension Plate
(see diagram right).
To make any adjustments, use the
Tightening Tool supplied.
Top of
Display
There are two mounting hole configurations:
UÊÇxÊÝÊÇx““
UК£ддКЭК£дд““
Choose appropriate Mounting Screws
from the Hardware supplied to suit
your Display.
Mounting Screws (x4)
VESA Plate
Back of Display
Зx““
(3”) £дд““
(4”)
Зx““
(3”)
£дд““
(4”)
Step 7. Attach the VESA plate to your Display
Step 8. Attach your Display to the POS Assembly
Step 9. Adjust the VESA Ball Mount Advanced Security Installation
PUSH
Push down firmly to attach the Top Cap.
Hook the top of the VESA plate onto
the Quickshift Mount. Gently push the bottom of the Display
into the Mount until you hear a ‘CLICK’. Insert the Security Screw, and tighten
using the 2mm Allen Key supplied.
Tighten (+Kg)
Loosen (-Kg)
Tension
Plate
Tightening
Tool
Security
Screw
CLICK
PUSH
HOOK
TIGHTEN
Back of Display
2mm
Allen Key