Cortech RSL-2701 - Manual (Page 4)

7
FPower Switch (1) -
Located on the rear of
the machine. “I” (on) “0” (off). (Fig. 2)
Cross Cutter (2) -
Used to cut off the
laminated web. (Fig. 2)
Figure 2
Feed Guide (3) –The feed guide permits
alignment of the item(s) to be laminated. To
position the adjustable guide, loosen the knob,
slide it to the desired position and tighten the
knob to secure the feed guide in place. (Fig.3)
Safety Shield (4) – It prevents entanglement
NOTE: If the safety shield is opened, the power
to the motor will turn off.
Figure 3
Film Shaft and Locking
Core Adapter (5)
–
The film shaft holds the film supply on the
machine. The locking core holds and locks the
film on the shaft to prevent shifting. (Fig.4)
Figure 4
Film Tension Adjustment (6) – Allows the
operator to increase or decrease film web
tension. To increase the tension turn the knob
clockwise and to decrease tension turn the
knob counterclockwise. (Fig. 5)
Figure 5
①
②
③
④
8
Idler bar
OPERATING INSTRUCTION
1. Turn the laminator ON (I) located on the rear of the machine. (Fig. 2)
2. Choose appropriate laminating thickness and speed. (Fig. 1)
3. Do not begin laminating until the blinking light is steady (approximately 10 minutes).
4. Position the item to be laminated on the feed table.
5. Press the RUN button. The rollers will begin to turn, wait for heat line to disappear,
feed the item into the machine.
6. Stop the laminator when all of the items have completely exited the rear of the
machine.
Repeat the above steps until all of your lamination is completed. When lamination is
completed the machine is not in use for an extended period of time turn the power off.
NOTE: Stand by mode and auto power off mode
- Stand by mode: If no activity is made within 30 minutes after each use the
machine will automatically switch into stand by mode. (In stand-by mode the
temperature will decrease to 80~90℃ (176~194°F) and the three film thickness
setting indicators will blink).
- Auto power off mode: If the machine is in stand by mode and no activity is
made for 60 minutes the machine will automatically power off.
- If any activity is made while in stand by or auto power off mode the machine
will return to it’s previous stage.
FILM LOADING & THREADING
Figure 6
Upper
roll film
Lower
roll film
Roller
Idler bar
Laminating
direction