Cortech RSL-2701 - Manual (Page 6)

11
▲ LOADING LOWER ROLL FILM
1. Repeat steps 1-5 to load lower roll film.
2. Once the upper and lower film is on the shaft, pull the film from the top roll down to
the bottom roll to make certain that the film is aligned properly. Then tighten the
lower locking core screws.
NOTE: If the film is not aligned properly exposed adhesive will adhere to the rollers
and may cause the film to jam.
▲ FILM THREADING
Refer to Figure 6
MAINTENANCE
1. Do not apply any cleaning fluids to the rollers certain fluids may cause damage.
2. Do not clean rollers with sharp or pointed objects.
3. Use adhesive remover to clean resin off of the rollers.
4. Use a damp cloth with water to clean the body of the machine.
5. Store machine in a dry clean area.
12
TROUBLE SHOOTING GUIDE
Problem Cause Remedy
Rollers do not operate
after the RUN/STOP
Button is pressed
1. Safety cover is opened.
2. Power cord is not
plugged in
3. Machine is not turned
on.
1. Check safety cover is
properly closed.
2. Plug in the power
cord.
3. Turn the machine on.
Roller is not heating Call your authorized dealer Call your authorized dealer
Poor Lamination
1. Unbalanced film
tension.
2. Lower idler bar is not
properly positioned
3. Wrong
temperature/speed
setting
1.Adjust film tension
2. Push idler bar in proper
position
3. Follow manufacturers
recommended
temperature and speed.