Velleman VDLP56LBS User Manual

Velleman Lighting

Advertising
background image

VDLP56SBS / VDLP56LBS / VDLP56SCS / VDLP56LCS

1

VELLEMAN

VDLP56SBS / VDLP56LBS / VDLP56SCS / VDLP56LCS – PAR56 PROJECTOR

1. Introduction


To all residents of the European Union
Important environmental information about this product

This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.

Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised

company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.

Thank you for buying the VDLP56SBS / VDLP56LBS / VDLP56SCS / VDLP56LCS! Please read the manual
thoroughly before bringing this device into service. Unpack your device carefully. It should come with: 1 x short or long

PAR56 spot, 1 x clamp, 1 x safety cable and 4 x colour filter. If the device was damaged in transit, don't install or use it
and contact your dealer.

2. Safety Instructions

Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer

will not accept responsibility for any ensuing defects or problems.

A qualified technician should install and service this device.

Do not switch the device on immediately after it has been exposed to changes in temperature. Protect the device

against damage by leaving it switched off until it has reached room temperature.

This device falls under protection class I. It is therefore essential that the device be earthed. Have a qualified
person carry out the electric connection.

Make sure that the available voltage does not exceed the voltage stated in the specifications of this manual.

Do not crimp the power cord and protect it against damage. Have an authorised dealer replace it if necessary.

Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.

There may be some smoke or a particular smell when the device is activated for the first time. This is normal and
any smoke or smell will gradually disappear.

Do not look directly at the light source as sensitive people may go into epileptic seizure if they do.

Note that damage caused by user modifications to the device is not covered by the warranty.

Keep the device away from children and unauthorised users.

3. General Guidelines

This device is designed for professional use on stage, in discos, theatres etc. The VDLP56SBS / VDLP56LBS /
VDLP56SCS / VDLP56LSC

should only be used indoors with an alternating current of max. 230VAC / 50-60Hz.

Lighting effects are not designed for permanent operation: regular operation breaks will prolong their lives.

Do not shake the device. Avoid brute force when installing or operating the device.

Be very careful during the installation: touching live wires can cause life-threatening electroshocks.

Do not touch the device during operation as the housing heats up.

Keep this device away from rain and moisture.

Unplug the mains lead before opening the housing.

Advertising
Table of contents