Velleman VDPC146 - Manual (Page 7)

VDPC146
V. 02 – 21/10/2013 7 ©Velleman nv
3. Release the EDIT button. The yellow LED indicator of the selected scene is lit.
4. Bring the speed fader down (to SHOW MODE) and use the STEP button to find the scene to be deleted.
5. Press the DELETE button to remove the step.
6.9 Inserting or Adding a Step to a Programme
1. Press MODE SELECT to select 1-24 SINGLE / PRESET PARK. The green LED indicator lights.
2. Use the PAGE button to select the page (1 – 4) where the scene is to be added or inserted.
3. Slide both master faders (MASTER A = 0 and MASTER B = 10) to the lowest position, place the FADE slider
in the highest position and the SPEED slider in the lowest position (SHOW MODE).
4. The channel fader of the step to be inserted should be slid upwards.
5. Press RECORD.
6. Select CHASE/SCENES (red LED indicator is lit) with the MODE SELECT button.
7. Hold the EDIT button.
8. Press the flash button of the scene that has to be inserted in that step.
9. Release the EDIT button (the yellow LED indicator of the selected scene is lit).
10. Press the STEP button until you reach the scene that will immediately follow the scene to be inserted.
11. Press INSERT to add the scene to that programme step.
12. Hold the RECORD button.
13. Press the REC EXIT button.
14. Release both buttons to leave the programming mode.
6.10 Selecting and Running a Programme
1. Press MODE SELECT until the green LED indicator marked ‘1-24 SINGLE / PRESET PARK’ is lit.
2. Select the desired page (1 – 4) with the PAGE button.
3. Slide the MASTER faders to the highest position.
4. Move the channel slider for the scene in question to the lowest and then the highest position to select and
run the programme stored under that fader.
6.11 Running a Programme with TAP SYNC rhythm control
1. Make sure the music control function is not active (press the AUDIO button to extinguish the AUDIO LED
indicator if necessary).
2. Press the PARK button to select MIX CHASE.
The yellow LED indicator is lit.
3. Select the programme you want to run.
4. Adjust the speed slider and press TAP SYNC twice to define the beat time.
5. Hold REC SPEED.
6. Press the appropriate flash button under PRESET B to store the new settings.
6.12 Running a Programme with the Speed Slider
1. Make sure the music control function is not active (press the AUDIO to extinguish the AUDIO LED indicator
if necessary).
2. Press the PARK button to select MIX CHASE.
The yellow LED indicator is lit.
3. Select the programme you want to run.
4. Move the speed slider all the way down to SHOW MODE.
5. Hold REC SPEED.
6. Press the appropriate flash button under PRESET B to store the new settings.
The programme is now controlled through the real-time movement of the SPEED control.
Programming example
1. Put the device in the programming mode (see 6.2 Activating the Recording Mode)
2. Press MODE SELECT until the green LED indicator marked ‘1-24 SINGLE / PRESET PARK’ is lit.
3. Slide both MASTER faders and the FADE slider to the highest position and the SPEED slider to the bottom.
4. Select page 1 with the PAGE button.
5. Slide channel faders 1-3-5-7-9-11-13-15-17-19-21-23 to the top.
6. Press RECORD.
The LED display shows 001.