Velleman VDL50CM3 - Manual (Page 3)

VDL50CM3_v3 HQPOWER 3
• Do not look directly into the light source as sensitive people may go into epileptic
seizure if they do.
• Note that damage caused by user modifications to the device is not covered by
the warranty. Keep the device away from children and unauthorised users.
3. General Guidelines
• This device is a light effect for professional use on stages, in discos, theatres,
etc. This device should only be operated with an alternating current of max.
230VAC/50Hz and is designed for indoor use only.
• This device is not designed for uninterrupted operation. Frequent operation
breaks will prolong the life of your VDL50CM3.
• Do not shake the device. Avoid brute force when installing or operating the
device.
• Select a location where the device will be protected against extreme heat,
moisture and dust. Respect a min. distance of 50cm between the VDL50CM3s
light output and the illuminated surface
• Secure the device with an appropriate safety cable (VDLSC7 or VDLSC8).
• Do not use the device if the ambient temperature exceeds 45°C. The max.
temperature for the housing is 130°C.
• Familiarise yourself with the functions of the device before actually using it. Do
not permit operation by unqualified people. Any damage that may occur will
probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• Note that all modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short-
circuits, burns, electroshocks, lamp explosion, crash, etc. Using the device in an
unauthorised way will void the warranty.
4. Installation
a) Installing or Replacing a Lamp
CAUTION : Only install a lamp when the device is unplugged from the mains and
replace it if it has been damaged in any way.
• The lamps can reach temperatures of up to 700°C during operation, so you
should let them cool down for at least 10 minutes before replacing them
• Do not touch the halogen bulbs with your bare hands. Use a cloth to handle the
lamps during insertion and removal.
• Do not install lamps with a higher wattage as they generate higher temperatures
than those for which the device is designed.
Procedure
1. Unscrew the cap on the front panel (immediately beneath the lens).
2. Pull the ring containing the lens towards you.
3. Remove the old lamp and insert the new one.
4. Carefully push the ring back into place.
5. Fasten the cover.