Velleman VDL301GL - Manual (Page 4)

VDL301GL Rev. 01
22.10.2009 ©Velleman nv 4
• Do not look directly at the light source as sensitive people may go into epileptic
seizure if they do.
• Keep the device away from splashing and dripping liquids. Never put objects
filled with liquid on top of the device.
• Note that damage caused by user modifications to the device is not covered by
the warranty.
• Mechanical wear is not covered by warranty.
• Keep the device away from children and unauthorised users.
3. General Guidelines
Refer to the Velleman ® Service and Quality Warranty on the last pages of this
manual.
• This device is designed for professional use on stage, in discos, theatres, etc.
The VDL301GL should only be used indoors with an alternating current of max.
230 VAC~50 Hz.
• Lighting effects are not designed for permanent operation: regular operation
breaks will prolong their lives.
• Do not shake the device. Avoid brute force when installing or operating the
device.
• Select a location where the device is protected against extreme heat (see
“Technical Specifications”), dust and moisture. Respect a minimum distance of
0.5 m between the device’s light output and any illuminated surface.
• Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).
• Familiarise yourself with the functions of the device before actually using it. Do
not allow operation by unqualified people. Any damage that may occur will most
probably be due to unprofessional use of the device.
• Use the original packaging if the device is to be transported.
• All modifications of the device are forbidden for safety reasons.
• Only use the device for its intended purpose. All other uses may lead to short
circuits, burns, electroshocks, crash, etc. Using the device in an unauthorised
way will void the warranty.
4. Installation
a) Fuse
• Only fit or replace a fuse when the device is unplugged from the mains.
• Replace a blown fuse with a fuse of the same type and rating (see “Technical
Specifications”):
1. Remove the fuse holder at the back of the device.
2. Remove the old fuse and install a new one.
3. Replace the fuse holder.