Velleman VDPL300CB User Manual
Page 4
VDPL300CB
V. 01 – 05/07/2012
4
©Velleman nv
•
Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.
•
All modifications of the device are forbidden for safety reasons. Damage caused by user modifications
to the device is not covered by the warranty.
•
Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, lamp explosion, crash, etc. Using the device in an unauthorised way will void the
warranty.
•
Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and
the dealer will not accept responsibility for any ensuing defects or problems.
•
Mechanical wear and LEDs are not covered by warranty.
•
A qualified technician should install and service this device.
•
Do not switch the device on immediately after it has been exposed to changes in temperature.
Protect the device against damage by leaving it switched off until it has reached room temperature.
•
This device is designed for professional use on stage, in discos, theatres, etc. The VDPL300CB should
only be used indoors. Use only the included power adapter.
•
Lighting effects are not designed for permanent operation: regular operation breaks will prolong their
lives.
•
There may be a particular smell when the device is activated for the first time. This is normal and
any smell will gradually disappear.
•
Do not repeatedly switch the fixture on and off. This shortens the life time.
•
Keep away from electronic equipment that may cause interference.
•
Never leave the device running unattended.
•
Use the original packaging if the device is to be transported.
•
Keep this manual for future reference.
4.
Features
•
compact but bright LED effect
•
82 lenses projecting a multitude of coloured beams over 360°
•
DMX-512 control possible via 6 channels (RGB separate colour control, rotation, shutter and effect
control)
•
stand-alone, master/slave or sound-activated mode via built-in microphone
•
very low power consumption, long lifetime and no lamp replacements.
5.
Overview
Refer to the illustrations on page 2 of this manual.
Front Back
1
display
4
DMX input
2
control buttons
5
DMX output
3
microphone
6
fuse holder
7
power supply
6.
Installation
Mounting the device
•
Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.
•
The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.
•
The installation must always be secured with a secondary attachment e.g. a safety cable.
•
Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.
•
Install the device in a location with few passers-by that is inaccessible to unauthorised persons.