Velleman CSR1 - Manual

CSR1 1 VELLEMAN
CSR1 – PROFESSIONAL METAL DETECTOR
1. Introduction
Thank you for buying the CSR1! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, don't use it and contact your dealer.
2. Assembly
Open the carton and remove the main housing assembly. Twist the plastic stem lock at the end of the upper stem to
allow the lower stem to be inserted. Adjust the length and rotate the lower stem to wrap the cable around the stems
and take up any slack. Push the cable into the cable slots to hold it firm while allowing enough cable for free
movement of the search head. Turn the stem lock to fix it at the desired position.
1. Battery compartment
13. Headphone socket
14. Battery compartment
2. Upper shank & handle grip
3. Control box + socket
8. LCD display
9. Menu / Scroll button
10. Pinpoint push button
11. Enter button
12. Power on / off & volume control
4. Stem connecting nut
5. Cable
6. Lower stem
7. Search head fastener
3. Batteries & Battery Check
The CSR1 is powered by eight AA batteries (not supplied). It is advisable to use standard alkaline batteries to start
with. You can then evaluate the sort of use you give the detector and decide whether the investment in
rechargeables is justified.
The batteries should be fitted in the holder which is located in the battery compartment. To fit new batteries first
check the power switch on the unit is switched to OFF. Then loosen the two captive screws located in the battery
cover (do not fully remove these from the cover) and remove the cover. Inside is the battery holder. Lift out the holder
and detach the connector if it is already fitted. Load it with the eight batteries ensuring that each battery is inserted
the correct way round, (direction of batteries alternating). Roll each individual battery to ensure it is located correctly
and making proper contact. Replace the connector making sure that it is firm and well seated, and put the loaded
holder into the housing. Fit the cover and tighten the two captive screws finger tight.