Velleman CSR1 - Manual (Page 7)

CSR1 7 VELLEMAN
OPTIONS
DISCRIM GR’ND TYPE DEFAULT
SENSITIVITY OPTIONS LAST
AUDIO RECALL MANUAL OFF
PROGRAMS STORE MANUAL ON
SET UP BACK
This allows the operator to select which settings are restored when the CSR1 is switched on. Highlight the desired
choice using the MENU/SCROLL control and then press the ENTER button.
DEFAULT (setting): this will tell the CSR1 to load the factory default settings every time it is switched on.
LAST (setting): if MANUAL mode is selected (see below) this will tell the CSR1 to switch on with exactly the same
settings as when it was last used. This enables you to turn the CSR1 off when digging for deep targets and then
switch it back on and resume your searching without having to readjust the detector.
MANUAL OFF: turns the manual mode off so when you turn on the CSR1 you are presented with a short -cut to the
easy to use manufacturer defined programs of:
-COIN INLAND for general purpose searching on most sites i.e. those not affected by very high mineralization
or salt deposits.
-ALL METAL for very deep searching of all metals (no discrimination).
-COIN BEACH for general purpose searching on the beach or highly mineralised sites.
MANUAL ON: turns the opening selection screen off so that when you turn on the CSR1 you are immediately in the
searching mode. Experienced users may prefer this setting.
RECALL
DISCRIM GR’ND TYPE COIN INLAND
SENSITIVITY OPTIONS ALL METAL
AUDIO RECALL COIN BEACH
PROGRAMS STORE USER 1
SET UP BACK USER 2
Recalls all settings from the program selected from the list (see also MANUAL OFF above).
STORE
DISCRIM GR’ND TYPE USER 1
SENSITIVITY OPTIONS USER 2
AUDIO RECALL
PROGRAMS STORE
SET UP BACK
Stores all current settings into the program selected, either USER 1 or USER 2.
f. Setup
DISPLAY
DISCRIM DISPLAY CONTRAST
SENSITIVITY GROUND ADJ BRIGHTNESS
AUDIO FREQUENCY
PROGRAMS BATTERY
SET UP BACK
These options allow the display settings to be adjusted. These settings are stored when the CSR1 is switched off and
will be restored when it is turned back on. To select, highlight the desired option by rotating the MENU/SCROLL
control and the press the ENTER button.
CONTRAST: sets the contrast level or viewing angle of the display. Once set it shouldn’t require adjustment.
However, if the CSR1 is used at dawn or dusk when the sun is low in the sky then some adjustment may be required
to improve the visibility of the display. The desired level should be set by rotating the MENU/SCROLL control and
then pressing the ENTER button when satisfied, this will store the setting.