Toner Cable RTC 360 Cable Pro RTC 360 Crimp Tool - Manual (Page 2)

Telephone: Nationwide: Fax: E-mail: Internet:
215-675-2053 800-523-5947 215-675-7543 [email protected] http://www.tonercable.com
Toner Cable Equipment, Inc. Specifications Subject To Change Without Notice.
Ca
ble Pr
o R
T
C 360 and F-Conn Connector
s
FFC C FF-C CO ON NN N IIN ND DU USSTTR RIIEESS R RG G-6 6 & & R RG G-5 59 9 FF C CO ON NN NEEC CTTO OR RSS
FEATURES
1. Internal Rings are drawn into smaller rings around the outer jacket. This forms
two small, half O-Rings out of the cable’s outer jacket (see Figure 1).
2. The internal post is extended to provide a larger surface area at the crimp point
(See Figure 2).
3. This reduction provides space for the braid to be folded back. The braid cannot
reach the crimp area (Figure 1), and therefore the O-Ring seal is preserved. By
keeping the loose braid out of the crimp area, we reduce the chance of uneven
braid distribution that might cause an impedance problem. The 360° crimp pro-
vides exceptional pull out strength while creating a 360° tight electrical connec-
tion (See Figure 3).
WR SERIES WRO SERIES
The WRO Series incorporates an
O-Ring in the nut for added sealing
against moisture and dirt.
CONNECTOR I.D. O-RING CABLE SIZE UNIVERSAL
RG-6 NR .342 NO QUAD TO 67% YES
RG-6 NRO .342 YES QUAD TO 67% YES
RG-6 WR .336 NO TRI TO 67% YES
RG-59 WR .312 NO QUAD TO 53% YES
RG-6 WRO .336 YES TRI TO 67% YES
RG-59 WRO .312 YES QUAD TO 53% YES
Connectors to use with CABLE PRO RTC-360 Crimper