Shindy 17-657B Radial Brake Master Cylinder Kits User Manual
Page 2
Instructions:
*Should be operated by and expert or under expert supervision to avoid damages or accidents.
1. Drain front brake fluid from Front Brake Caliper(s) completely.
2. Remove the brake switch coupler, banjo bolts and brake hose from the stock master
cylinder. Cover the stock master cylinder and brake hose with a rag to prevent spills.
3. Remove the stock master cylinder from the handle bar.
4. Mount ○
1
Radial master cylinder on the handle bar with ○
9
Half clamp (or ○
8
Mirror
holder) and allen cap screws. Connect the brake switch coupler.
5. Mount the ○
2
Reservoir tank on ○
1
Radial master cylinder with ○
7
Reservoir Bracket,
○
5
Reservoir bolt and ○
6
Tank fixing nut. Make sure the reservoir tank is not too slanted.
6. Connect brake hose(s) to ○
1
Radial master cylinder with M10 x P1.25 banjo bolt.
Fastening torque: 25-30Nm. New gasket must be used.
*The brake hose banjo(s) must be far
enough from the Brake Switch Pushing Arm
on the brake lever. Make sure the Pushing
Arm DOES NOT hit the banjo(s) when the
brake lever is fully stroked. Any returned
products with a bent pushing arm will not
be honored.
7. Take off the reservoir cap and pour brake fluid into the reservoir tank.
8. Let the air bleed through to the reservoir by squeezing the ○
3
Hose and stroking the
lever several times until you feel the pressure.
9. Connect the air bleeding hose to the air bleeder and stroke the lever. While holding
the lever down, loosen the air bleeder. When the air comes out, close it again. Repeat
until there is no more air to come out. Finally close the air bleeder with 4-7Nm torque.
10. Check the lever pressure by stroking the brake lever several times. Make sure the
brakes properly works before riding.
11. Hold the lever down stiffly to make sure the lever does not move. Check for any
brake fluid leakage. Check all bolts and nuts to make sure they are all tight.
IMPORTANT: Shindy Products, Inc. cannot be held liable for any damage to the product, motorcycle or
persons and property caused by failure to follow the mounting and maintenance instructions exactly.
SHINDY PRODUCTS, INC.
1566 CENTRE POINTE DR.
MILPITAS, CA 95035
OK
NG