Shindy 17-863 Digital Tachometer - Manual (Page 2)

CONTENTS
Part Quantity
○
1 Digital tachometer 1
○
2 Coupler 1
○
3 Fastening tape 1
○
4 Sensor Type A 1
○
5 Sensor Type B 1
- owner's manual 1
INSTALLATION
Using the fastening tape ○
3 , install the digital tachometer ○ 1 to a location where it can be easily read.
Connecting the ignition pulse sensor lead
The ignition pulse sensor lead can be connected in two different ways.
Fig A : Use SENSOR TYPE A
*Wind the ignition pulse sensor lead onto spark plug cord, then secure it with insulating tape
Fig B : Use SENSOR TYPE B
*Directly connect the ignition coil's positive wire.
For 4 cycle engine, this "Primary Wiring" is more recommended in order to display an accurate engine speed.
**Be sure to ground the black GND-code even if the LED light code is not connected to external battery in
order to stabilize the display. Non resistor spark plug or racing plug may cause display freeze. If this is the case,
change it to a resistor spark plug.