Rough Country 1169 - Manual

TJ \ YJ D-RING MOUNT
Thank you for choosing Rough Country
Please read instructions before beginning installation. Check the kit hardware against the parts list and product
layout. Be sure you have all needed parts and know where they go. Also please review tools needed list and make
sure you have needed tools.
If questions exist we will be happy to answer any questions concerning the design, function, and correct use of this
product.
TJ INSTALLATION INSTRUCTIONS
1. Remove the factory hardware and factory hook if equipped using a T-55 torx head bit that secures the
bumper to the front frame rails as shown in Figure 1. TJ installation shown. The rear holes in the d-ring
bracket will not be used on the TJ application.
2. On the TJ using the supplied 1/2” x 1 3/4” hardware, install the d-ring mount in the 2 factory holes as shown
in Figure 2. Installation shown using factory bumper.
3. Tighten hardware to 65 ft/lbs specs.
4. Repeat for opposite side.
5. Install d-ring as shown in Figure 3.
Kit Contents:
2-D-ring mounts
2-D-rings
4-1/2” X 1 3/4” Bolts
4– 1/2 Washers Tools Needed:
T-55 torx bit / rachet
3/4”-socket
92116900
FIGURE 1 FIGURE 2