Rough Country 1169 - Manual (Page 2)

FIGURE 3
1. Remove the factory hardware using the T-55 torx head bit that secures the bumper to the front frame rails as
on the TJ. The center holes in the d-ring bracket will not be used on the YJ application.
2. If using this kit with a factory bumper, you will have to trim the plastic frame cover to expose the 2 rear holes.
If used with the Rough Country winch mount or aftermarket winch mount the bracket will install on top of the
winch mount and no trimming will be required but a longer bolt may be required to accommodate the extra
thickness of the winch plate.
3. On the YJ using the supplied 1/2 x 1 3/4” hardware, install the d-ring mount in the 2 factory holes. Tighten
hardware to 65 ft/lbs.
4. Install d-ring as shown in Figure 3.
YJ INSTALLATION INSTRUCTIONS