Rough Country 1054 - Manual (Page 2)

INSTALLATION INSTRUCTIONS
1. Place vehicle on a flat surface and set emergency brake.
2. Using a small phillips screwdriver, remove the 2 plastic screws on top of the front bumper cover. Retain Stock hard-
ware. See Photo 1.
3. Remove the 4 plastic screws holding the skid plate to the front bumper, using a small Phillips screw driver Retain
stock hardware. See Photo 2.
4. Using a 18mm socket, remove the 4 bolts holding the bumper to the frame horn on the driver and passenger side.
See Photo 3.
5. Find the plug for the fog lights and unplug. Remove bumper. See Photo 4.
6. Remove the stock tow hook brackets if equipped.
7. After the bumper is removed. Remove the factory fog lights using a Phillips screwdriver. See Photo 5.
8. Drill the mounting holes in the factory fog lights using a 1/4” bit. See Photo 5.
9. Install the factory fog lights in the new bumper with the supplied hardware.
Photo 1 Photo 2
Photo 3 Photo 4
Photo 5 Photo 6
REMOVE BUMPER COVER HARDWARE REMOVE BUMPER COVER HARDWARE
REMOVE BUMPER HARDWARE REMOVE BUMPER COVER HARDWARE
REMOVE THE FOG LIGHTS (IF EQUIPPED) ENLARGE THE MOUNTING HOLES
REMOVE BUMPER COVER HARDWARE