Rough Country 1031 - Manual

97-06 JEEP TJ 7” FLARE KIT
Thank you for choosing Rough Country for all your suspension needs.
Please read instructions before beginning installation. Check the kit hardware against the parts list on this page.
Be sure you have all needed parts and know where they go. Also please review tools needed list and make
sure you have needed tools.
Kit Contents:
Rear Driver Flare
Rear Pass Flare
Front Driver Flare
Front Driver Lower Flare
Front Pass Flare
Front Pass Lower Flare
1-Hardware Bag
92103100
Tools Needed:
Pliers
8MM Socket / Wrench
10mm Socket / Wrench
11MM Socket / Wrench
REAR INSTALLATION INSTRUCTIONS
1. Starting on the rear, remove the plastic trim retainer as shown holding the inner fender skirting in place on
the front of the rear fender well.
2. Remove the plastic debris flap hardware as shown using a 8mm & 11mm socket and remove the flap. Re-
tain hardware.
PHOTO 1 PHOTO 2
11mm
8mm
REMOVE THE PLASTIC RETAINER