Rough Country 1031 - Manual (Page 3)

FRONT INSTALLATION INSTRUCTIONS
1. Remove the front lower leg of the fender flare using a 8mm wrench. See Photo 1.
2. Remove the bulb and harness from the front flare lights. See Photo 2.
3. Remove all he stock flare hardware using a 8mm wrench. Remove the flare from the vehicle. See Photo 3.
4. Remove the stock lens from the flare using a 10mm socket. See Photo 4.
5. Reinstall the lens in the appropriate fender flare and tighten using a 10mm wrench.
6. Install the lower leg of the fender flare and tighten using a 8mm wench. See Photo 5. Lightly snug the hard-
ware, do not over-tighten the hardware.
7. Install the new flare on the vehicle using the supplied hardware. See Photo 6. Tighten using a 8mm wrench.
Lightly snug the hardware, do not over-tighten the hardware.
PHOTO 1 PHOTO 2
PHOTO 3 PHOTO 4
PHOTO 6 PHOTO 5
REMOVE THE STOCK FASTENERS REMOVE LIGHTING HARNESS
REMOVE THE STOCK HARDWARE REMOVE THE LENS
INSTALL THE LOWER FLARE REMOVE THE PLASTIC RETAINER