Rough Country 720.20 - Manual (Page 4)

13. As shown in Photo 7, using a 15mm wrench and vise grips on the end of the pin, remove the ubolt plate and bolt.
14. After removing plate, flip bolt in insert on the opposite side as shown in Photo 8.
15. Using a 15mm and vise grips, re-tighten pin into the shown position in Photo 9.
16. Install Socket Head Bolt and nut into the plate as shown in Photo 10. *note direction of plate when placing bolt*
17. Using a 9/16 wrench and 5/16 Allen wrench, tighten bolt in place. Photo 11
18. Using 21mm socket and wrench, remove the stock shackle and retain stock hardware. Photo 12
PHOTO 1
PHOTO 7 PHOTO 8
PHOTO 9 PHOTO 10
PHOTO 11
PHOTO 12