Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Six-Gun Diesel Tuner w_ optional Speed-Loader Module For use with Six-Gun switch Only - Manual (Page 6)

6
96450 v.9.0
The Banks Six-Gun Diesel Tuner
has six power levels adjustable by
the supplied Six-Gun switch. Level
1 is stock. Each additional higher
level adds approximately 20% of the
available power increase. To prevent
damage to the factory transmission,
Banks recommends that both
automatic and manual transmission
vehicles do not exceed Level 4 while
the vehicle is experiencing load
(towing, climbing a steep grade,
carrying a load, etc.).
To use the higher levels of the Six-Gun
Diesel Tuner while towing or climbing,
airflow improvements must be made
to lower the exhaust gas temperature
(EGT) entering the turbo. The EGT
should not exceed 1400º F for more
than a few seconds. Elevated EGT
can damage the turbocharger and the
engine.
Attention!
Before proceeding with these
instructions, please carefully read
the DISCLAIMER OF LIABILITY
and LIMITATION OF WARRANTY
statement located on page 4 of
this manual.
TOOLS REQUIRED:
Six-Gun module
• Inch and metric sockets
• Inch and metric combination and
open-end wrenches
• Pliers
• Ford stereo removal tool
(’03-04 model year vehicles only)
• Wire cutters
• Scissors
• Drill motor
• 1 ⁄
8
” drill bit
• 13 ⁄
32
” drill bit
Additional tools required for
Thermocouple installation
• 7 ⁄
16
” drill bit
• Tap handle
• 1 ⁄
4
” NPT tap
Highly recommended tools and
supplies for Thermocouple:
• Foot-pound torque wrenches
• Penetrating oil or light lubricant
spray
• Anti-seize compound
• Heat gun
Dear Customer,
If you have any questions
concerning the installation
of your Banks Six-Gun Diesel
Tuner, please call our Technical
Service Hotline at (888) 839-
2700 between 7:00am and
5:00pm (PST). If you have any
questions relating to shipping
or billing, please contact our
Customer Service Department
at (888) 839-5600.
Thank you.
General Installation Practices