Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Six-Gun Diesel Tuner (235, 250, 305, 325 HP Dodge 5.9L Cummins (24-valve) Trucks) '03-05 Compatible with Optional PowerPDA - Manual (Page 34)

34
96807 v.9.0
If the Six-Gun Diesel Tuner should ever
need to be removed from the vehicle,
perform the following:
NOTE: The ignition must remain in the
OFF position throughout the removal
process.
1.
Disconnect the Six-Gun’s Fuel Rail
Pressure (FRP) connections from the
vehicle’s FRP sensor and harness.
2.
Re-connect the vehicle’s FRP
connector back into the FRP sensor.
3.
Disconnect the Six-Gun’s Manifold
Absolute Pressure (MAP) connections
from the vehicle’s MAP sensor and
harness.
4.
Re-connect the vehicle’s MAP
connector back into the MAP sensor.
5.
Disconnect the Six-Gun’s
crankshaft Position (cKP) connections
from the vehicle’s cKP sensor and
harness..
6.
Re-connect the vehicle’s cKP
connector back into the cKP sensor.
7.
Disconnect the Six-Gun’s Camshaft
Position (cMP) connections from the
vehicle’s cMP sensor and harness.
8.
Re-connect the vehicle’s cMP
connector back into the cMP sensor.
9.
Unbolt the Six-Gun’s ground ring
terminal from the fender stud and re-
tighten the stud’s 10mm nut.
10.
Unplug the Six-Gun’s RED/WHT
power wire from the mini-fuse tap and
remove the tap.
11.
Disconnect the 2 ring terminals
nearest the Six-Gun from the EGT
thermocouple lead wire.
12.
Disconnect the 3 small
connectors on the Six-Gun’s in-cab
cable and gently pull the cable back
through the firewall.
13.
Remove the Six-Gun Diesel Tuner.
NOTE: Failure to follow the above
instructions when removing the Six-
Gun Tuner will result in a “Check
Engine” light on the dash and a
Diagnostic Trouble Code being stored
in the factory computer, in addition to
the engine not running.
-END, SECTION 11-
Section 11
REMOVAL OF THE SIx-GUN DIESEL TUNER