Banks Power Backup Camera For use with Banks iQ 2.0 - Manual (Page 7)

97275 v.1.0
7
length if necessary on the Red wire to
reach the power source. Crimp the spade
connector to the Red wire and plug it into
the t-tap power source.
7.
Locate a place on the vehicle chassis
where a good ground connection can
be made. Use the supplied ring terminal,
serrated washer and sheet metal screw
to connect the Black wire to ground.
Once the ground connection is made, it
is recommended to cover the connection
with RTV Silicone or similar to prevent
corrosion.
WaRNiNG: Do not reverse the
polarity of the wires! Damage
to the iQ may occur. Make sure
to connect the Red wire to the
power source and the Black wire to
ground.
-END, SECTION 2-
Figure 2 Left Side Edge
section 3
sETUP & UsE
setup
1.
Make sure that the wheels of the
vehicle are blocked so that the vehicle
cannot move. Engage the parking
brake on the vehicle and turn the key
to the RUN position without starting
the vehicle. Move the shifter to the
Reverse position.
2.
The backup camera should
automatically display an image on the
iQ. See Figure 3.
NOTE: Allow up to 10 seconds for the
image to appear. This process can be
delayed during initial startup of the iQ.
3.
The image will show a colored grid
in the bottom half of the screen. If
the grid is not at the bottom half of
the screen, tap the left side of the iQ
screen to rotate the image until it is in
the proper position. Tapping the right
hand portion of the screen will invert
the image from True to Mirror.
4.
With the image on the iQ screen,
adjust the camera position by slightly
loosening the bezel and rotating the
camera in its mount until the image is
level, then retighten the bezel.
5.
When satisfy with the image
position, go over the installation and
secure any loose wiring away from any