Banks Power 2001-2005 Chevrolet 6.6L Duramax Turbo-Diesel Pickups User Manual
Page 11
9.
Locate the Banks MAF sensor
o-ring supplied in your kit. Install
Banks o-ring as shown. Ensure o-ring
is flush to MAF sensor edge as shown
Note: Retain stock o-ring. Keep stock
o-ring in place, you will be installing
the Banks o-ring while retaining the
original o-ring on the MAF sensor. See
Figure 9.
10.
Locate your Banks Ram-Air intake
tube in your kit. Install the stock MAF
sensor (with the additional Banks o-
ring) to MAF sensor mounting boss as
shown. Tighten screws to 3 in/lbs.
Note: Ensure correct alignment as
shown otherwise screw holes will not
align with screw holes in the Banks
Ram-Air intake tube. See Figure 10.
Caution: Do NoT oVER TIGHTEN
SCREWS
11.
Locate the Banks compressor
inlet hose and hose clamps from your
Banks Ram kit. Loosely fit the hose
clamp onto your Banks inlet hose.
Install the Banks inlet hose and hose
clamp and tighten it to the compressor
inlet. See Figure 11.
12.
Install Banks Ram-Air intake
tube to Banks inlet hose and hose
clamp. Lightly tighten the hose clamp.
Note: leave the clamps snug to allow
movement of the inlet hose to allow
correct alignment. See Figure 12.
13.
Locate the previously removed
stock air box and remove the stock air
filter Minder. Make sure to remove the
stock air filter Minder rubber grommet
as well. See Figure 13.
14.
Locate the Banks Ram-Air filter
housing cover. Install the previously
removed air filter minder rubber
grommet into the Banks Ram-Air filter
housing cover. Once rubber grommet
is installed flush into the Banks Ram-
Air cover, then locate the previously
Figure 9
96453 v.3.0
11