Installation – Grain Systems Unload Augers PNEG-1550 User Manual
Page 13
Advertising
PNEG-1550 Belt Guard
13
Installation
c. The Horizontal Drive on 8'' Double-Drive Vertical Augers requires disassembling the
Motor Mount components to remove/replace the Belt Guard Brackets.
i. After the motor has been removed, loosen the 3/4'' Hex nut underneath the
Motor Mount Sides, holding down the Motor Mount Assembly.
Motor Mount
Sides
3/4'' Hex
Nut
Motor Mount
Assembly
Figure 4C
ii. Remove the Motor Mount Assembly.
iii. Unbolt the four (4) 1/2'' x 1'' Hex bolts, lock washers, and Hex nuts, and remove
the existing Belt Guard Brackets.
Motor Mount
Sides
Lock Washer
Hex Nuts
1/2'' x 1'' Hex Bolts
Belt Guard
Brackets
Figure 4D
Advertising