Install gate frame to trough – Grain Systems Bucket Elevtors, Conveyors, Series II Sweeps PNEG-765 User Manual
Page 8
Advertising
8
PNEG-765 Gate Manual
1. Assemble the gate frame to the bottom of the trough section using the existing hardware in
the trough bottom.
2. Adjust the carry over bars flush to the bottom of your conveyor. (Note: Failure to adjust carry
over bars properly will cause severe damage to chain and/or gate.
3. It is preferred that the gate is oriented so it closes towards the head section.
Figure 10
Gate Assembly
Trough Section
Carry Over Bars
Install Gate Frame to Trough
Advertising