Snap-On DTT - Manual (Page 12)

Setup
Mounting
Vertical mounting on a wall or heavy pillar is preferred for
most wrench and tool testing as shown in the illustration
below. Use four 1/4” diameter bolts (torqued to 10 FT LB)
to insure a secure mount. The DTT can also be mounted
vertically to a horizontal surface using a right angle
bracket.
A – Mounting Screw (4)
B – Right Angle Bracket
10
DTT Digital Torque Tester
Figure 3: Mounting, Dimensions and Right Angle Bracket
A
B
8.87”
8.87”
2503-F-DTT
25 - 250 FT.LB.
Mount the DTT to a sturdy support before use. Torque
testing procedures may involve hundreds of pounds of
load. Be sure to consider counterweight of the mount to
accommodate torque testing operations and testing
fixtures. Allow enough room around and below the mount
for the wrenches or testing fixtures being used.