Snap-On DTT - Manual (Page 19)

17
DTT Digital Torque Tester
6b. Press the CHANGE button next to WRENCH SIZE to
enter the Full Scale torque and Units of the wrench
being calibrated (Figure 14).
NOTE: If the incorrect value is entered, press BS to
clear the last digit entered, or press CLEAR to
delete the entire entry.
Press UNITS to scroll between FT-LB, IN-LB,
IN-OZ, KG-CM, Nm and cNm units.
Press NEXT to accept the entry and return to the
TEST SETUP screen.
NOTE: For information on how to update
SERIAL NUM, and
OPERATOR ID;
please refer to Steps 5c & 5d.
Press TEST to accept all entries.
ENTER WRENCH MAX RANGE :
MAIN CLEAR NEXT UNITS
Figure 14: Wrench Max Range screen
FT-LB
250
1 2 3 4
5 6 7 8
9 0 BS