Daystar KA09100BK - Manual (Page 3)

40. Jack up the axle and reconnect the shocks, track bar and sway
bar end link. Be sure the coil springs are seated properly.
41. Tighten all the shock bolts, track bar bolt, and sway bar links
to factory specifications.
42. Install the rear tires.
43. Lower off the jack stands.
44. Tighten front and rear lug nuts to factory specifications.
45. Double-check all fasteners for proper clearances and torque.
Installation steps
1. Place the vehicle on level ground.
2. Open the hood and disconnect the battery. Remove the
battery from the vehicle.
3. Remove the 4 14mm battery try bolts and the one nut at
the fuse box. Push the battery tray to the side.
4. Remove the cover off the electrical plug box to the rear of
the battery tray and the remove 10mm nut from the center
of the box .
5. Pull up on the box to get to the 2 12mm bolts under the
box. Remove the bolts and move the purge valve bracket
and electrical box to the side.