Daystar KA09100BK - Manual (Page 5)

29. Reinstall the ABS sensor and tighten all the upper strut bolts
and lower bolts to factory specifications.
31. Repeat steps 14 through 29 on the passenger side.
29. Install the battery tray and air box assemblies in the opposite
order they were removed..
31. After both front lift spacers are installed , re-install the front
wheels and lower to the ground and re-install the sway bar
end links.
32. Jack up the rear suspension and put the jack stands under the
frame rail in front of the rear tires. Remove the rear tires.
33. Leave the floor jack under the axle.
34. Disconnect the sway bar end links and rear shocks at the
axle. Unbolt the track bar at the frame on the driver side.
11. Jack up the vehicle and place jack stands under the frame rail
behind the front tires. Lower the vehicle on to the stands.
12. Remove the two front tires.
13. Disconnect both the driver and passenger side sway bar end
links. You may have to place a floor jack under the lower
control arm and take some load off the end link.
14. Unbolt the brake line bracket from the strut.
15. Carefully remove the ABS sensor from the front
wheel.
16. Remove the 3 upper strut nuts.
17. Remove the lower strut nut.