Speedhut SST-MAX OBDII Shift-Light (CAN Protocol) User Manual
Obdii, Connect to vehicle’s odbii port, Obdii can (j1979) protocol pinout
Programming buttons
OBDII
Connector
SST-MAX OBDII Shift Light instructions [CAN (J1979) protocol]
OBDII CAN (J1979) protocol Pinout
If the vehicle has wires that connect to pins 6 and 14 of the OBDII connector
then the vehicle supports the CAN (J1979) protocol.
Pin 4 -- Chassis Ground
Pin 5 -- Signal Ground
Pin 6 -- CAN High (data)
Pin 14 -- CAN Low (data)
Pin 16 -- +12volt Battery power
1. Plug the OBDII connector into the vehicle's ODBII port.
Note: Use the included double sided tape or a screw (not inlcuded). Arrange the shift light cable so that it will not interfere with steering wheel, gear stick, or pedals.
Installation Instructions
1. Disconnect negative (-) Battery Cable
Note: Use the included double sided tape or a screw (not inlcuded).
5. Reconnect negative (-) battery cable.
Red Wire (connect to 12volt power)
White wire (connect to CAN High)
to Shift Light
Black Wire (connect to CAN Low)
Unshielded Wire (connect to Chassis
Ground)
Connect to vehicle’s ODBII port
WARRANTY - Speedhut inc. warrants to the consumer for a period of 5 years from the date of purchase that the product will be free from defects in materials or workmanship.
Speedhut warrants to the consumer for a "LIFE-TIME" that the product circuit board will be free from defects in materials or workmanship.
Please contact Speedhut service department If you have a problem with this gauge.
Speedhut Inc. 165 North 1330 West B2, Orem, Utah 84057 | [email protected] | (801) 221-1460 (9am - 5pm MST)
OPTIONAL: Direct Wire instructions (hard wire the SST-MAX Shift-Light into a PCM/ECU)
Vehicle’s OBDII connector pin numbering
Power Note: There is no need to disconnect the shift light when not in use. The SST-MAX Shift-light will automatically go int
OBDII NOTE: Speedhut SST-MAX Shift-light will not function when used in conjunction with any other OBDII device.
o a power saving mode when the
vehicle is off. When the engine is started up the Shift-light will instantly be powered on and ready to use.