Speedhut SST-MAX OBDII Shift-Light (CAN Protocol) - Manual (Page 2)

Set Shift Point for each Gear
Note: Engine RPM will show as this example: 8.35 = 8350 RPM
2. Toggle through to set your desired shift point.
3. To save setting, do not press a button for 5 seconds. Display will blink indicating that the setting has been saved.
4. Repeat procedure to set shift point for each gear.
menu option. press and hold a button for 2 seconds. Current setting will be displayed.
to
Select the Number of Speeds for your Vehicle’s Transmission
Program the SST-MAX to your Vehicle’s Gear Ratios
1.Turn on power to the Shift-light by starting up the vehicle (or plug it into the ODBII port).
2. To access most menus follow this procedure below.
A quick press
enters menu mode
A quick press
toggles menus
Press hold 2 secs
to select menu
The SST-MAX OBDII Shift light is equipped with an easy to use LED display menu. The LED display by default will display your engine RPM.
The SST-MAX can quickly learn your car’s gear ratios, which allows you to setup a different shift point for each individual gear.
WARRANTY - Speedhut inc. warrants to the consumer for a period of 5 years from the date of purchase that the product will be free from defects in materials or workmanship.
Speedhut warrants to the consumer for a "LIFE-TIME" that the product circuit board will be free from defects in materials or workmanship.
Please contact Speedhut service department If you have a problem with this gauge.
Speedhut Inc. 165 North 1330 West B2, Orem, Utah 84057 | [email protected] | (801) 221-1460 (9am - 5pm MST)
Initial Setup Instructions
1. Select the menu option, press and hold a button for 2 seconds. Current setting will be displayed.
2. Toggle through 1 through 6 to select how many speeds your transmission has.
3. To save setting, do not press a button for 5 seconds. Display will blink indicating that the setting has been saved.
1. Select the
1. Select the
menu option, press and hold a button for 2 seconds. is displayed.
2. Drive the vehicle in 1st gear at a steady speed. Quick press a button, LEDs will blink to indicate 1st gear ratio is saved.
will automatically be displayed after the 1st gear ratio is set.
3. Drive the vehicle in 2nd gear at a steady speed. Quick press a button, LEDs will blink to indicate 2nd gear ratio is saved.
will automatically be displayed after the 2nd gear ratio is set.
4. Repeat procedure for each remaining gears.
Please note: Driving speed only needs to be steady for each gear and does not need to be close to the red line. For example 5th and 6th gears
would be driven at a safe and legal speed (50-70MPH) while corresponding lower gears would be driven at slower steady speeds.
Please note: Program menu is only available while engine is running.
1.
2.
3.
Power Note: There is no need to disconnect the shift light when not in use. The SST-MAX Shift-light will automatically go into a power saving mode when the
vehicle is off. When the engine is started up the Shift-light will instantly be powered on and ready to use.