Speedhut 2-1_16 inch, 2-5_8 inch, & 3-3_8 inch Revolution_Legacy Gauge - Manual

2-1/16”, 2-5/8”, and 3-3/8” Revolution/Legacy Gauge Instructions
Ground (black)
+12 volts Dash lighting (white)
(Yellow)
snap connector for dial lighting
Voltage gauge
12 volt
power source
(Black)
snap connector for dial lighting
Pressure gauges
(Black)
snap connector for dial lighting
Temperature gauges
1.Disconnect negative (-) Battery Cable
2.Connect wiring as above.
3.Mount Gauge for easy viewing. Use spin lock ring (included) to mount to panel. Spin ring
threads in both directions. Snap white gauge connector to wire harness.
4.Reconnect negative (-) battery cable.
1/8 npt threads
1/8 npt threads
Ground (black)
+12
Ground (black)
+12
+12 volts Keyed ignition (Red)
(Black) Ground
(White) +12 volts Dash lighting
Power distribution cable to plug all gauges into
+12 volts (Red)
(Black) Ground
(White) +12
Power distribution cable to plug all gauges into
+12 volts (Red)
(Black) Ground
(White) +12
Power distribution cable to plug all gauges into
Clock Gauge
+12 volts Battery voltage
Connect to contstant 12Volts (Red)
(Black) Ground
Ground
+12
Note: To adjust time use included 3.5mm jack plug
button.
1. plug into back of gauge.
2. press and hold button to rotate clock hands to
current time
Note: Tie both lighting white wires together
and both black ground wires together.
Note: Tie both lighting white wires together
and both black ground wires together.
Note: Tie both lighting white wires together
and both black ground wires together.
(Gauge Dial lighting)
(Gauge Dial lighting)
(Gauge Dial lighting)
(Gauge Dial lighting)
(Main gauge power)
(Main gauge power)
(Main gauge power)
(Pointer (needle) lighting)
(Pointer (needle) lighting)
(Pointer (needle) lighting)
Note: Clock Hands do not glow at night
INVERTER
INVERTER
INVERTER
INVERTER
Keyed ignition
Keyed ignition
volts Dash lighting
volts Dash lighting
volts Dash lighting (white)
volts Dash lighting (white)
volts Dash lighting (white)
will remain in last powered position.
will remain in last powered position.
will remain in last powered position.
Harness Wires:
White wire - Signal
Black wire - Ground
Harness Wires:
White wire - Signal
Black wire - Ground
Red wire - 5 volt reference
Power Draw = 0.2 Amp
5 Amp Inline Fuse Recommended
for +12 Keyed Ignition
Power Draw = 0.2 Amp
5 Amp Inline Fuse Recommended
for +12 Keyed Ignition
Inverter Note: INVERTER IS REQUIRED FOR GAUGE DIAL LIGHTING. E18-686-5CR is single
gauge inverter to light single gauge. C01-18N-2 and C11-18A01 are multiple gauge
lighting inverters that can light up to 6 - 8 gauges depending on inverter model.
See Inverter Note
See Inverter Note
See Inverter Note
See Inverter Note
Power Draw = 0.2 Amp
5 Amp Inline Fuse Recommended
for +12 Keyed Ignition
Trimable area
DO NOT trim pass the slot.