Speedhut Edge Attitude Pillar, Pod, and Mount User Manual
Page 2
www.Speedhut.com Need help? Contact us: Speedhut Inc. 165 North 1330 West B2 Orem, Utah 84057 or call 801-221-1460
www.Speedhut.com Need help? Contact us: Speedhut Inc. 165 North 1330 West B2 Orem, Utah 84057 or call 801-221-1460
Model #13002 are designed to fit 99-06 Ford Super Duty (2 velcro strips)
Installation Instructions: Ford Super Duty 99-06 overhead console mount
STEP ONE: Attach the two Velcro pieces together. Peel back strip to expose adhesive from one side and attach to the
recessed area of the mount where the Attitude fits.
STEP TWO: Expose adhesive and install Attitude in mount. Press firmly to engage adhesive to back of Display.
(Do not press on LCD)
STEP THREE: Apply Velcro to rear of Pod.
STEP FOUR: Clean window area where Velcro attaches.
STEP FIVE: Peal backing off Velcro.
Note: In step 6 be careful not to let Velcro touch windshield.
STEP SIX: Insert top edge of pod back into the space between the windshield and the metal roof edge, located under
the headliner.
STEP SEVEN: Feed wiring under headliner for several inches and slide pod into position above rear view mirror.
STEP EIGHT: Push pod firmly up against head liner.
STEP NINE: With pod firmly against head liner, press bottom of pod against windshield, apply firm pressure to bond
Velcro to window.
Note: Hold firm pressure for at least one minute. Continue running wiring under headliner and down a-pillar.
Model #13002 are designed to fit 99-06 Ford Super Duty (2 velcro strips)
Installation Instructions: Ford Super Duty 99-06 overhead console mount
STEP ONE: Attach the two Velcro pieces together. Peel back strip to expose adhesive from one side and attach to the
recessed area of the mount where the Attitude fits.
STEP TWO: Expose adhesive and install Attitude in mount. Press firmly to engage adhesive to back of Display.
(Do not press on LCD)
STEP THREE: Apply Velcro to rear of Pod.
STEP FOUR: Clean window area where Velcro attaches.
STEP FIVE: Peal backing off Velcro.
Note: In step 6 be careful not to let Velcro touch windshield.
STEP SIX: Insert top edge of pod back into the space between the windshield and the metal roof edge, located under
the headliner.
STEP SEVEN: Feed wiring under headliner for several inches and slide pod into position above rear view mirror.
STEP EIGHT: Push pod firmly up against head liner.
STEP NINE: With pod firmly against head liner, press bottom of pod against windshield, apply firm pressure to bond
Velcro to window.
Note: Hold firm pressure for at least one minute. Continue running wiring under headliner and down a-pillar.