Speedhut Freedom Tachometers with built in Shift-light - Manual

Freedom CAN-bus 4” Tachometer with Shift-Lights
WARRANTY - Speedhut inc. warrants to the consumer for a period of 5 years from the date of purchase that the product will be free from defects in materials or workmanship.
Speedhut warrants to the consumer for a "LIFE-TIME" that the gauge circuit board will be free from defects in materials or workmanshipPlease contact Speedhut service dept.
If you have a problem with this gauge. [email protected]
Over Rev
Red #2
Shift point
Red #1
Brightness LED
Yellow #3
Span LED
Yellow #2
Shift LED
Yellow #1
Select
button
0 RPM
50 RPM
100 RPM
150 RPM
200 RPM
(factory default)
250 RPM
300 RPM
350 RPM
400 RPM
(fig #2)
x 1000
x 1000
Menu
button
Set your shift point and RPM span
One of the most exciting features of the Freedom tachometer with shift-lights is the
integrated shift LED's in the dial. This new technology lets you anticipate the next shift
point by displaying 3 yellow warning LED's before reaching the set shift point Red #1
LED. The span between the LED's can also be set. Red #2 is an over-shift light that
blinks if you exceed the set shift point by the set span value. If, for any reason you
miss a shift and over-shoot your shift point this light will blink.
The following procedures can be done at any time during operation of the
tachometer while the tachometer has power.
Shift point set
Red #1 is set shift point. The 3 Yellow LEDs will turn on before the set shift point
by the amount of span selected.
1. Press and release menu button until 'shift' LED is lit.
2. Press and release 'select button. LED will blink once to indicate you have selected the
RPM shift point.
3. Set shift point.
Press and hold 'Select' button to increase RPM shift point.
Press and hold 'Menu' button to decrease RPM shift point.
After desired shift point is reached release buttons for 2 seconds. LED will blink 2 times to
Shift RPM Span set
will turn on the next LED after 400 RPM of previous LED.
Example: shift point set at 6500, span set at 200 RPM.
yellow #1 will light at 5900, yellow #2 at 6100, yellow #3 at 6300, red #1 (shift point) at
1. Press and release menu button until 'span' LED is lit.
2. Press and release 'select button. LED will blink once to indicate you have selected
the RPM span point.
3. Set RPM span.
Press and hold 'Select' button to increase RPM span.
Press and hold 'Menu' button to decrease RPM span.
After desired span is reached release buttons for 2 seconds. LED will blink 2 times to
Set your LED brightness
A unique day and night LED brightness setting can be set on the Freedom tachometer with shift-lights. Each setting has 4 possible brightness positions
lighting. Setting the LED brightness value with your lights 'on' will result in setting the 'night' brightness value. And likewise, setting the LED brightness
To set LED brightness, press and release menu button until Brightness LED is lit. Press and release select button. Press and release select button to
increase brightness. Press and release menu button to decrease brightness. After 2 second delay LED will blink to indicate setting has been saved.
Memory function (Peak Recall)
1. To show peak recall press and release peak (select) button.
Peak RPM will be displayed for a couple seconds.
After couple second delay tachometer will go back to normal operation.
2. To clear peak RPM press and release peak (select) button. During the peak RPM display press and release peak button again. This clears the RPM.
LED will blink to indicate memory cleared.
Cleaning Window
- Use warm soap water or Windex to clean the window.