Speedhut Freedom Tachometers with built in Shift-light - Manual (Page 2)

Freedom CAN-bus 3-3/8” and 2-1/16” Tach with Shift-Lights
WARRANTY - Speedhut inc. warrants to the consumer for a period of 5 years from the date of purchase that the product will be free from defects in materials or workmanship.
Speedhut warrants to the consumer for a "LIFE-TIME" that the gauge circuit board will be free from defects in materials or workmanshipPlease contact Speedhut service dept.
If you have a problem with this gauge. [email protected]
x 1000
Button on front of
the gauge
Shift Lights
Set your shift point
The following procedures can be done at any time during operation of the tachometer while the tachometer has power.
Shift point set
1. Press and HOLD button for approx 10 seconds. Pointer will travel to current set shift point.
2. Press and Hold to move pointer up and down dial. Releasing button and pressing and holding again will change pointer direction.
3. At desired shift point, release button for 5 seconds. LED will blink and pointer will return to zero position on dial. New shift point is now stored in
memory.
Peak memory recall feature
Press and hold gauge button down and gauge needle will display maximum peak reading for as long as button is pressed down. LED will stay lit while
showing peak reading. Note if button is held for longer than 10 seconds, tach will enter shift light set mode. (see step - Set your shift point)
To retain peak reading (NOT CLEAR IT)
While showing peak reading, release button, wait 2 seconds, gauge will return to normal and retain the peak reading.
To clear peak reading
zero to indicate peak has been cleared
Set your shift light LED brightness
connected to your dash lighting. Setting the LED brightness value with your lights 'on' will result in setting the 'night' brightness value. And likewise,
At any time while tachometer has power, press and release LED button to show current LED brightness. After a couple second delay, if button is not
pressed this current setting is re-saved. LED will blink to indicate setting has been saved. To change LED brightness press and release the button to
At acceptable brightness level do not press button for couple second delay. LED will blink to indicate setting has been saved. Note: Setting the
brightness level.
3-3/8” version
2-1/16” version
Shift Light