Turbosmart BOV ADAPTERS - Toyota Soarer - Manual (Page 4)

SOARER TT BLOW-OFF VALVE ADAPTOR INSTRUCTIONS
Head Office: Turbosmart Pty Limited, PO Box 264 Croydon, NSW, 2132 Australia Ph: +61(2) 9798 2866 Fax: +61 (2) 9798 2826 Email: [email protected]
USA Office: Turbosmart USA, 1185 Park Center Drive, Suite Q, Vista CA 92081 USA Ph: (760) 727 7610 Fax: (760) 727 7963 Email: [email protected]
PART NUMBER
FG-ADM-SOARER
Step 15. Undo the hose clamp on the top of the
factory intercooler pipe, using a 10mm socket.
Step 16. Undo the hose clamp on the bottom of the
factory intercooler pipe, using a 10mm socket.
Step 17. Remove the factory intercooler pipe.
Important! You may need to increase the
clearance between the Soarer TT adaptor and car
battery to accommodate for the BOV. To increase
the clearance you may have to adjust or replace the
car battery with a smaller unit.
Step 18. Fit the Silicon hose couplers over the Soarer
Adaptor. Note that the hose couplers are of different
diameters to suit the larger and smaller ends of the
adaptor. Install your Turbosmart BOV onto the
adaptor by following the instructions included with the
BOV.
Step 19. Fit the adaptor between the intercooler and
the throttle body. Using two of the 90mm hose clamps
supplied, secure the Silicon hose coupler onto the
Soarer adaptor and the throttle body.
Step 20. Using two of the 70mm hose clamps
supplied, secure the Silicon hose coupler onto the
Soarer Adaptor and the intercooler pipe.
Clearance