Turbosmart WASTEGATES – EXTERNAL - Hyper-Gate 45 (no locking ring) - Manual (Page 2)

www.TURBOSMARTONLINE.com
2
Best Flow – Symmetric Mounting
Symmetric mounting allows an excellent flow of exhaust to the
Hyper-Gate.
Good Flow – Angled Mounting
Angled mounting allows a good flow of exhaust to the Hyper-Gate.
RECOMMENDATIONS FOR MOUNTING YOUR HYPER-GATE
The mounting position of your Hyper-Gate will be largely determined
by your turbo and manifold setup and may be constrained by space
restrictions in your engine bay. The following points should be
considered when mounting your Hyper-Gate.
- The weld flanges should be welded to your exhaust
system. The weld flanges are compatible with Stainless
Steel and Mild steel welding rod material.
-
The Hyper-Gate45 valve seat is compatible with the Tial
44 weld flange. If you have an existing Tial 44 weld flange
on your manifold, you can mount the Hyper-Gate45
directly onto the flange using the V-Band clamp supplied
with the Hyper-gate45.
-
Secure the Hyper-Gate to the weld flanges with the
supplied V-Band clamps. Do not forget to put the valve
seat into the body before mounting the unit on the
exhaust manifold. Tighten the supplied M6 screws to a
torque value of 14 Nm (10 ft/lbs)
-
For best results an attempt should be made if space
allows to mount the Hyper-Gate at an angle to the
exhaust flow to allow for better flow than a 90 degree
mounting. See the schematic diagrams below for
examples of mounting positions.
Exhaust Gas
from manifold
Turbocharger Turbine
Wastegate
Exhaust gas
to exhaust
pipe
Exhaust gas
to exhaust
pipe
Exhaust Gas
from manifold
Wastegate
Turbocharger Turbine