Moog Music MF-105M MIDI MuRF (Manual Addendum - Firmware v1.8) User Manual

Page 7

Advertising
background image

The MIDI MuRF’s FILTERS

The MIDI MuRF contains 8 filters that can be configured for bass or

mid-frequency voicing by the FREQ slide switch on the front panel.

In the BASS voicing, the lowest filter acts as a lowpass filter with a

cutoff frequency of 110 Hz. This is ideal for bass players or bass sounds

that need to retain the presence of all their lowest frequencies. The

remaining seven filters are resonant filters with center frequencies of 160,

240, 350, 525, 775, 1200 and 1800 Hz.

In the MIDS voicing, all 8 filters act as resonant filters with center

frequencies of 200, 300, 450, 675, 1000, 1500, 2200, and 3400 Hz.

The MIDS voicing is very good for processing sounds with dense mid-

frequency harmonics, including guitars, vocals, or synthesizer pad

sounds.

Each filter has a slider that adjusts the gain of that filter. In this

respect, the MuRF resembles a graphic equalizer. When a filter’s slider

is all the way down, the gain for that filter is zero, and the filter’s

output is zero. When the slider is all the way up, the filter’s output is

at maximum. However – the resemblance to a graphic EQ ends there.

The MuRF’s filters have characteristics that set them far apart from a

graphic equalizer. First, they are resonant filters. They boost the signal

at the center frequencies of the filters. Second, they are tuned so they

don’t overlap. A graphic equalizer will theoretically not color the signal

at all when all the sliders are set to the same level. The MuRF’s resonant

filters on the other hand color the signal a great deal, adding warm analog

resonances at pleasing intervals throughout the frequency spectrum.

We’ll now show how the MIDI MuRF’s filters affect the MF-105M’s

frequency response. We will always start with this ‘basic’ panel setup,

shown in figure 5, which is:

1) Set each of the filters’ sliders to all the way up.

2) With the FREQ switch in the MIDS position, switch the PATTERN to

Pattern 1. When Pattern 1 is active, the Animation is turned off so you

page 7

Advertising