Moog Music Animoog for iPhone - Manual (Page 4)

COmETS
COmETS are visual representations of each voice that is triggered when a key is
pressed. These
COmETS travel through the X/Y grid as visual feedback regard-
ing each note’s place in a timbre.
Note: If no Path or Orbit module parameters have been assigned, pressing a key simply
causes the Origin to glow.
PATHS AND ORbITS
Each voice follows a path based on settings in the PATH module. Voices can
also be made to orbit a path by using the ORbIT module.
CREATING A PATH AND ORbIT
Select the X/Y PAD from the main menu.
Select the PATH tab on the right to
access the PATH module.
Press the Edit button to create
or edit a path (Red light on).
CREATE: Touch points on the grid
to create a path. New nodes will
automatically connect to each other.
EDIT: Touch and drag nodes to
new locations.
DELETE: To delete a node, simply
double tap it.
When your path is complete, press
the
EDIT button again.
PATH mODULE PARAmETERS
The RATE control determines how fast
each COmET moves along the path.
Note: High settings create complex
sounds and geometric shapes in the X/Y grid.
mODE: determines how comets travel
through a path.
LOOP: Comets follow the path from beginning to end repeatedly.
bACK-FORTH: Comets move between the start and end point of a path repeat-
edly.
ONCE: Comets follow the path from beginning to end and latch to the end point.
SYNC: Sets the Path RATE to be a multiple or division of Animoog’s current BPM.
• CLEAR: Erases any existing path and nodes.