TC Electronic D-Two - Manual (Page 8)

6
FRONT PANEL OVERVIEW
POWER button
Power on/off.
IN LEVEL knob
Adjusts the Input level.
At center position a relay will
switch the Input circuit
between consumer and pro
level. This will insure optimal
Input Gain range and superb
“signal to noise” ratio is
achieved.
MIX knob
Adjusts the global mix between
dry and wet signal. Fully
clockwise position is 100%
effect.
IN meters
The IN peak meter shows the
Input level of left and right
channels. The meter range is:
0, -3, -6 ,-12, -18, -24, -40dB.
OVERLOAD LEDS
The OVERLOAD LEDs
indicate one of two situations:
- The Input level is too hot
and therefore overloading.
- There is an internal DSP
overflow.
The OVERLOAD LED is lit
when 1 sample is @ 0dBFS.
DELAY TIME indicator
The DELAY TIME indicator can
display Delay time in either ms
(milliseconds) or BPM (Beats
Per Minute). This is selected in
the Setup menu. The ms or
the BPM icon next to the Delay
time will be lit accordingly.
The tempo is also indicated via
the blinking TEMPO/RHYTHM
indicator.
SUBDIVISION indicator
The selected subdivision
determines the recalculation of
the tapped tempo. Example:
At 120BPM you tap 1/4 notes.
The tapped time equals
500ms. If the Subdivision is
set to 1/8, the D•TWO now
recalculates the Delay time to
250ms.
DYNAMIC meter
Indicates the gain reduction on
the Delay Output when using
the Dynamic Delay algorithm.
EDITED icon
This icon will be lit as soon as
the current recalled preset has
been modified.
FACTORY/USER icon
Shows whether you are
operating in the Factory or the
User bank.
MIDI IN icon
Indicates the presence of
incoming MIDI information.
SAMPLE RATE indicator
The SAMPLE RATE indicator
shows the clock source and
the incoming master clock.
The “DI” icon will be blinking if
no clock or unacceptable clock
is found.
FEEDBACK %
The amount of level fed back
to the Delay line. Indicates the
Decay time of the Delay
repeats.
FEEDBACK #
The exact number of repeats.
FB FILTER LEDS
Indicates the Feedback High
and Low Cut filter setting.
FILTER LEDS
Indicates the overall High and
Low Cut filter setting.
PINGPONG LEDS
Indicates the panning currently
processed.