Rainbow Electronics MAXQ1004 - Manual

_______________________________________________________________ Maxim Integrated Products 1
For pricing, delivery, and ordering information, please contact Maxim Direct at 1-888-629-4642,
or visit Maxim’s website at www.maxim-ic.com.
MAXQ1004
1-Wire and SPI Authentication Microcontroller
Note: Some revisions of this device may incorporate deviations from published specifications known as errata. Multiple revisions of any device
may be simultaneously available through various sales channels. For information about device errata, go to:
www.maxim-ic.com/errata .
19-5258; Rev 0; 4/10
General Description
The MAXQ1004 is a low-power microcontroller that
integrates a 10-bit ADC, 1-Wire
M slave interface, SPIK,
AES encryption, random-number generator (RNG), and
temperature sensor with a 16-bit MAXQ
M pipelined CPU.
Performance bandwidth is sufficient to handle master
or slave challenge-response authentication in portable
devices.
The device incorporates 16KB of flash memory and 640B
of RAM. Factory programming of a customer secret key
is available upon request. The microcontroller runs within
a wide 1.7V to 3.6V operating range.
For the ultimate in low-power performance, an ultra-low-
power stop mode (300nA typ) is available. In this mode,
only a minimum amount of circuitry is powered to sup-
port detection of the start of a 1-Wire transaction. When
1-Wire activity is detected, the microcontroller is turned
on and the command is executed in an atomic fashion.
This allows for stateless operation between commands,
providing the highest reliability and lowest power con-
sumption.
Applications
Portable Electronics
Battery Chargers
Battery Packs
Ordering Information
Features
S High-Performance, Low-Power, 16-Bit MAXQ20
RISC Core
S
6MHz Operation from an Internal Oscillator,
Approaching 1MIPS per MHz
S
1.7V to 3.6V Wide Operating Voltage
S
Three Independent Data Pointers Accelerate Data
Movement with Automatic Increment/Decrement
S
Up to Eight General-Purpose I/O Pins
S
16-Level Hardware Stack
S
Optimized for C-Compiler (High-Speed/Density Code)
S
Memory
16KB Flash Memory, In-Application Programmable
640B of Data RAM
4KB of ROM
JTAG/TAP Bootloader Mode for In-System
Programming
S
Peripheral Features
10-Bit Delta-Sigma ADC, Internal Reference
1-Wire Slave Interface
On-Chip Power-On Reset (POR)/Power-Fail Reset
Overvoltage Detection
Programmable Watchdog Timer
Built-In Temperature Sensor, ±6NC
S
Secure Programming Interface
Flash Programming Through Secure ROM Loader
Secret Key Destruction on Mass Erase
Permanent Loader Lockout Option
Code and Secret Scrambling
S
Unique 64-Bit Serial Number
S
Low-Power Consumption
300nA (typ) in Stop Mode
3.75mA (typ) at 6MHz, 0.8mA (typ) at 1MHz
Low-Power Divide-by Modes (2, 4, 8, 256)
1-Wire/Interrupt Activity Detector
+Denotes a lead(Pb)-free/RoHS-compliant package.
*EP = Exposed pad.
1-Wire and MAXQ are registered trademarks of Maxim
Integrated Products, Inc.
SPI is a trademark of Motorola, Inc.
PART
TEMP
RANGE
AES
ENCRYPTION
PIN-
PACKAGE
MAXQ1004-B01+
-40 °C to
+85 °C
Yes
16 TQFN-
EP*