Rainbow Electronics MAX7032 - Manual (Page 6)

MAX7032
Low-Cost, Crystal-Based, Programmable,
ASK/FSK Transceiver with Fractional-N PLL
6 _______________________________________________________________________________________
AC ELECTRICAL CHARACTERISTICS (continued)
(Typical Application Circuit, 50 Ω system impedance, AV
DD = DV DD = PAV DD = HV IN = +2.1V to +3.6V, f RF = 300MHz to 450MHz, T A =
-40°C to +125°C, unless otherwise noted. Typical values are at PAV DD = AV DD = DV DD = HV IN = +2.7V, T A = +25°C, unless otherwise
noted.) (Note 1)
Note 1: Supply current, output power, and efficiency are greatly dependent on board layout and PAOUT match.
Note 2: 100% tested at T
A = +125°C. Guaranteed by design and characterization overtemperature.
Note 3: 50% duty cycle at 10kHz ASK data (Manchester coded).
Note 4: Guaranteed by design and characterization. Not production tested.
Note 5: Time for final signal detection; does not include baseband filter settling.
Note 6: Efficiency = P
OUT / (V DD x I DD ).
Note 7: Dependent on PC board trace capacitance.
Note 8: The oscillator register (0x05) is set to the nearest integer result of f
XTAL / 100kHz (see the Oscillator Frequency Register sec-
tion).
Note 9: Input impedance is measured at the LNAIN pin. Note that the impedance at 315MHz includes the 12nH inductive degenera-
tion from the LNA source to ground. The impedance at 434MHz includes a 10nH inductive degeneration connected from the
LNA source to ground. The equivalent input circuit is approximately 50
Ω in series with ~ 2.2pF. The voltage conversion is
measured with the LNA input matching inductor, the degeneration inductor, and the LNA/mixer tank in place, and does not
include the IF filter insertion loss.
Typical Operating Characteristics
(Typical Operating Circuit, PAV DD = AV DD = DV DD = HV IN = +3.0V, f RF = 433.92MHz, T A = +25°C, IF BW = 280kHz, data rate =
4kbps Manchester encoded, frequency deviation = ±50kHz, BER = 0.2% average RF power, unless otherwise noted.)
SUPPLY CURRENT vs. SUPPLY VOLTAGE
(ASK MODE)
MAX7032 toc01
SUPPLY VOLTAGE (V)
SUPPLY CURRENT (mA)
3.3 3.0 2.7 2.4
5.8
6.0
6.2
6.4
6.6
6.8
7.0
5.6
2.1 3.6
T A = +85 °C
T A = +125 °C
T A = +25 °C
T A = -40 °C
SUPPLY CURRENT vs. RF FREQUENCY
(ASK MODE)
MAX7032 toc02a
RF FREQUENCY (MHz)
SUPPLY CURRENT (mA)
425 400 325 350 375
6.1
6.2
6.3
6.4
6.5
6.6
6.7
6.8
6.0
300 450
T
A
= +85 °C
T A = +125 °C
T A = +25 °C
T A = -40 °C
SUPPLY CURRENT vs. RF FREQUENCY
(FSK MODE)
MAX7032 toc02b
RF FREQUENCY (MHz)
SUPPLY CURRENT (mA)
425 400 325 350 375
6.5
6.6
6.7
6.8
6.9
7.0
6.4
300 450
T A = +85 °C
T A = +125 °C
T A = +25 °C
T A = -40 °C
RECEIVER