Rainbow Electronics MAX17117 User Manual

Page 16

Advertising
background image

Internal-Switch Boost Regulator with Integrated

7-Channel Scan Driver, Op Amp, and LDO

MAX17117

16 _____________________________________________________________________________________

If the gate-shading control is enabled, a gate-shading
period is initiated by a falling edge of a CK_ input when-
ever V

DTS

is less than 100mV. Once the gate-shading

period is initiated, a switch across C

SET

(S

DTS

) opens,

allowing C

SET

to be charged through R

SET

. Once V

DTS

reaches 1.24V, S

DTS

closes to discharge C

SET

, the

gate-shading period is terminated, and the CKH_ output
states are directly determined by their corresponding
CK_ input logic states again. Once a gate-shading
period is initiated, V

DTS

must charge to 1.24V and sub-

sequently discharge back below 100mV, before the next
CK_ falling can activate a new gate-shading period.
By configuring R

SET

and C

SET

as shown in Figure 1, the

gate-shading period time duration is determined by R

SET

and C

SET

and V

LDOO

(see the Setting the Gate-Shading

Period Time Duration section). The gate-shading control
can be disabled by removing R

SET

. If R

SET

is removed,

the states of the CKH_ outputs are always determined by
their corresponding CK_ input logic states. See Figure 5.

Low-Dropout Linear Regulator (LDO)

The MAX17117 has an integrated 0.8I pass element
and can provide at least 350mA. The output voltage is
accurate within Q1%.

Thermal-Overload Protection

When the junction temperature exceeds T

J

= +170NC

(typ), a thermal sensor activates a fault-protection latch,
which shuts down all outputs, allowing the IC to cool
down. All outputs remain off until the IC cools and the
input voltage is cycled below, then back above the IN
UVLO threshold.
The thermal-overload protection protects the IC in the
event of fault conditions. For continuous operation, do
not exceed the absolute maximum junction temperature
rating of T

J

= +150NC.

Figure 4. Scan-Driver Block Diagram

CKH1

CKH3

CKH5

S1

S3

S5

RO

S

DTS

C

SET

R

O

R

SET

LDO

LDOO

CK1

CK2

CK3

CK4

CK5

CK6

LEVEL SHIFTER

AND

GATE-SHADING

LOGIC

DTS

CKH2

CKH4

CKH6

S2

S4

S6

RE

R

E

MAX17117

Advertising