Rainbow Electronics DS1854 - Manual (Page 17)

DS1854
Dual Temperature-Controlled Resistors with
Two Monitors
____________________________________________________________________ 17
MEMORY
LOCATION
EEPROM/
SRAM
R/W
DEFAULT
SETTING
NAME OF
LOCATION
FUNCTION
5 — — 0 ADEN
Controls if the device responds to one or two device
addresses (see the Memory Description section and
Table 5).
4 — — 0 ADFIX
Controls the means by which Main and Auxiliary Device
addresses are set (see the Memory Description section
and Table 5).
3 — — 0 APEN Controls auxiliary write protect. See Memory Description
2 — — 0 MPEN
Controls Main Device write protect. See the Memory
Description section.
1 — — 0 INV1
Configures buffer 1 with OUT1 = MINT +
(INV1 [XOR] IN1)
0 — — 0 INV2 Configures buffer 2 with OUT2 = INV2 [XOR] IN2
8A to 8B EEPROM — 00 Reserved —
8C EEPROM R/W A2 Device address
Contains Main Device address if the bit ADFIX = 1. If
ADFIX = 0, then address A2h is used.
8D to 8F EEPROM — — Reserved —
Table 01h (continued)
MEMORY
LOCATION
EEPROM/
SRAM
R/W
DEFAULT
SETTING
NAME OF LOCATION FUNCTION
80 to C7 EEPROM R/W FF Resistor 0 Temp LUT Look-up table for Resistor 0.
F0 to FF EEPROM R FF Reserved —
Table 02h
MEMORY
LOCATION
EEPROM/
SRAM
R/W
DEFAULT
SETTING
NAME OF LOCATION FUNCTION
80 to C7 EEPROM R/W FF Resistor 1 Temp LUT Look-up table for Resistor 1.
F0 to FF EEPROM R FF Reserved —
Table 03h