System considerations – Rainbow Electronics AT27C256R User Manual

Page 2

Advertising
background image

AT27C256R

2

The AT27C256R is available in a choice of industry stan-
dard JEDEC-approved one time programmable (OTP)
plastic DIP, PLCC, SOIC, and TSOP packages. All devices
feature two-line control (CE, OE) to give designers the flex-
ibility to prevent bus contention.

With 32K byte storage capability, the AT27C256R allows
firmware to be stored reliably and to be accessed by the
system without the delays of mass storage media.

Atmel’s 27C256R has additional features to ensure high
quality and efficient production use. The Rapid™ Program-
ming Algorithm reduces the time required to program the
part and guarantees reliable programming. Programming
time is typically only 100

µ

s/byte. The Integrated Product

Identification Code electronically identifies the device and
manufacturer. This feature is used by industry standard
programming equipment to select the proper programming
algorithms and voltages.

System Considerations

Switching between active and standby conditions via the
Chip Enable pin may produce transient voltage excursions.
Unless accommodated by the system design, these tran-
sients may exceed data sheet limits, resulting in device
non-conformance. At a minimum, a 0.1

µ

F high frequency,

low inherent inductance, ceramic capacitor should be uti-
lized for each device. This capacitor should be connected
between the V

CC

and Ground terminals of the device, as

close to the device as possible. Additionally, to stabilize the
supply voltage level on printed circuit boards with large
EPROM arrays, a 4.7

µ

F bulk electrolytic capacitor should

be utilized, again connected between the V

CC

and Ground

terminals. This capacitor should be positioned as close as
possible to the point where the power supply is connected
to the array.

Advertising